this is an engine surround that i made. its 8x8x12 ft. what it is used for is for storing an engine. the engine goes around to trade shows. those beams standing up marked left and right are actually ramps that raise up and down. the entire floor is at an angle so the engine will roll out. i attached a winch in the back to hoist it back after each show. i added tracks on the floor to guide the casters. i welded up the back wall today and added locks, padlocks to the front double doors too. i built this from blue prints!!!
today i started fabricating a huge metal catch all for a cement company that is resurfacing a bridge. hopefully i remember to take a picture tomorrow. the structure is 30 feet long!
No comments:
Post a Comment